Features:
Thrust ball bearing is separated type bearings, according to its structure is divided into one-way thrust ball and two-way thrust ball bearings . Bearing a single row thrust ball bearings to the heart, which has at the same time to bear a greater bearing axial load and radial load capacity .The thrust force ball bearing mainly applies to profession and so on automobile, engine bed . Our main products include deep groove ball bearings, thrust ball bearings, wheel bearings, clutch bearings, spherical bearing etc. Thrust ball bearings can be devided into single direction and double . Single direction thrust ball bearings, as their name suggests, can accommodate axial loads in one direction and thus locate a shaft axially in one direction. They must not be subjected to any radial load. Double direction thrust ball bearings can accommodate axial loads acting in both directions and can thus serve to axially locate a shaft in both directions. They must not be subjected to radial load.
Thrust ball bearings Features:
1. Available in two designs: single direction thrust ball bearings and double direction thrust ball bearings
2. To accommodate initial misalignments in an assembly both designs are available with spherical aligning seats or aligning seat washers.
3. High quality steel-ultra clean steel to extend bearing life by up to 80%.
4. Advanced Grease Technology - lubricants that can extend grease life and performance.
5. High Grade Balls - Quiet and smooth operation even at high speed.
6. Optional seating rings take initial misalignment.
Thrust ball bearing can be divided into 2 kinds:
■ Single direction thrust ball bearings
■ Double direction thrust ball bearings
Parameter:
Temperature limits for Bearing washers and balls |
-
125 °C (260 °F) when d ≤ 300 mm
|
-
150 °C (300 °F) when d > 300 mm
|
Cages |
Steel and brass cages can be used at the same operating temperatures as the bearing washers and balls. |
Seat washers |
Seat washers are made of steel and can be used at the same operating temperatures as the bearing washers and balls. |
Dimension standards |
ISO 104:2002 Bearings in the BA series are not standardized. |
Tolerances |
Normal P5 or P6 on request (single direction bearings only) |
Misalignment |
Accommodate initial misalignment between the support surfaces in the housing and on the shaft. |
Suffixes - Cage design |
F |
Machined steel cage, ball centred |
M |
Machined brass cage, ball centred |